Menu Close

Abu 501 / 506M Shallow Match Spool

(3 customer reviews)

£25.00 .

Abu 501 / 506m shallow match spool – Machined from bar stock aluminium and fitted with a rubber O ring top and bottom to help prevent fine lines getting behind / in front of the spool causing tangles

Out of stock

Abu 501 / 506m shallow match spool – Machined from bar stock aluminium and fitted with a rubber O ring top and bottom to help prevent fine lines getting behind / in front of the spool causing tangles

3 reviews for Abu 501 / 506M Shallow Match Spool

  1. Jason (verified owner) –

    Very good quality

  2. Nigel Pearson (verified owner) –

    Purchased 2 – they are really well engineered spools, fit perfectly in my ABU501 reels. The rubber O rings aren’t as good as the original ABU system with a chennile brush and with fine line, when left a bit slack (inevitable on occasion in a day’s fishing), found it could get under the spool and tangled. Easily solved however by adding a chennile brush to replace the rubber O Ring… these can be bought on e-Bay quite cheaply. Remove the O Ring, and drill a 1.5m hole through the channel where the O Ring sat… widen the hole a bit left/right with the drill bit to maybe 2mm then feed one end of the chennile wire brush through and bend the tip to be flush with the inside of the spool, then fit the chennile in the channel tightly around the spool and feed the other end through the same hole and trim off the excess, then bend the remaining 5-8mm tip against the inside of the spool to secure it… it now looks like the original ABU Delrin spool but with a far better aluminium machined core component.

  3. Nigel Pearson (verified owner) –

    To add to my review – if you add a chenille brush to the spool – you can use a 3-4mm diameter chenille at the bottom lip of the spool, but it needs to be 2mm diameter on the upper lip of the spool (to avoid too much friction on the rotating part of the spool).

Add a review

Your email address will not be published. Required fields are marked *